"T" slot couplings slide together to lock and uncouple with a pin key.
5/8" x 7-1/2 ft...for 1-1/4" through 3" lines up to 100 ft long;
7/8" x 15 ft....for 2" - 4" lines up to 125 ft. long.
Stability and Durability:
The Root 66 has a wide four point base for greater stability. Its interlocking tubular construction also gives it excellent durability. To protect the gears from dirt and for easier cleaning, the machine has two internal plastic shields. A ground fault circuit interrupter is standard equipment.
Drive both 5/8" and 7/8" cables without adjustment; also grip containers for smaller diameter cables.
With double-reinforced palm for hand protection when guiding cable.
Weight: 42 lbs. (19 kg) without cable
Two shields to protect bearings and motor from dirt and moisture.
Pull down two position handle to spin cables at 400 RPM. Lift to stop. Brake stops spinning drums instantly.
Sealed 1/2 hp with forward - off - reverse switch, ten foot power cord and ground fault circuit interrupter.
16" deep; 14" wide; 17" high. (40 cm x 35 cm x 43 cm).
Heavy gauge wire is coiled around 49 strand wire rope and then heat treated. This cable has unequalled strength and the right amount of flexibility. It's so tough, it has a one year warranty against defect or breakage. 3/4" diameter for 4-10" lines and 3" lines without sharp bends. 5/8" diameter for 3-6" lines.
R-8CS Cutter set for 5/8" cables:
Arrow Head, Boring Gimlet, 1-1/2" U-Cutter and Retrieving Tool.
R-10CS Cutter set for 7/8" cables:
Spear Head, 2" U-Cutter, 3" U-Cutter, Hook Auger and Retrieving Tool.