Two Way Chuck Handle:
Locked down against cable, you have both hands free to hold the cable. This is a real help when pulling cable out of the line.
Pneumatic Power Switch:
Power switch is located on handle for storage and use in "walk-in" operation. For close-up work, it's removed from handle for use as a foot switch.
Cable Feeding Tool:
It enables cable to get around tight bends and traps by taking advantage of open-wound design of cables. Note that operator controls machine by using power switch in foot pedal mode.
22" wide x 19" high with handle folded down.(56 cm x 48 cm)
90 lbs. (41 kg)
Heavy-duty 3/4 hp with capacitor and 20 ft. power cord rotates cables at 485 rpm. Equipped with ground fault circuit interrupter.
10" rubber rear wheels, 6" solid rubber caster wheel.
Locks rear wheels in place or releases them in an instant.
Combination Hand or Foot Operated Power Switch:
Air activated for safety; no electrical connection between motor and switch; can be used as hand or foot switch. Eleven foot air tube.
For better power transmission.
An adjustable spring-loaded clutch is mounted at the rear of the cable drive shaft. Accessible without removing machine housing.
Clamps on cable or acts as "dead-man's throttle."
Manually operated, to record number of cables in line.
Rear Cable Guide Hose:
To limit cable whipping behind machine.
Reduces truck storage space.
Cutter Set with "G" Connectors:
Spear Head, Hook Auger, 2" U-Cutter, 3" Heavy Duty Side Cutter, 3" Heavy Duty Saw Blade, 4" Rotary Saw Blade, Large Retrieving Tool, Coupling Wrench.
Cutter Set with "L" Connectors:
Spear Head, Hook Auger, 2" U-Cutter, 3" Heavy Duty Side Cutter, 3" Heavy Duty Saw Blade, 4" Rotary Saw Blade, Large Retrieving Tool,Coupling Wrench.