SRCS-R Cutter Set:
Senior Cutter Set for 5/8" and 3/4" Cables (Includes Spear Head, 2" U-Cutter, 3" Heavy Duty Saw Blade, and Large Retrieving Tool)
EJCS Cutter Set:
Cutter Set for 9/16" Cables (Includes Arrow Head, 1-1/2" U-Cutter, 2" U-Cutter, and Small Retrieving Tool)
Power Cable Feed:
The Sewerooter T-4's Power Cable Feed is a real labor saver. It enables you to vary feeding speed in and out of the line more easily and also gives you better control when working through tough stoppages. The Guide Tube reduces whipping and drag while protecting your hands from the spinning cable. Five foot Guide Tube Extensions are available.
Stair Climbers and Truck Loading Wheel:
Big ten inch heavy-duty semi-pneumatic wheels roll easily over rough terrain to and from the job. V-Belt stain climbers let you take the machine up a flight of stairs by yourself. Truck loading wheel in the handle makes it easier for one person to lift the machine into a truck bed.
The handle is tall enough to make it easy to move to the job, yet quickly folds to take less room in your truck.
Wire rope center construction. Heavy-gauge wire is coiled tightly around 49-strand aircraft-type wire rope and heat treated. It has unequalled strength and just the right amount of flexibility. So tough it carries a one-year warranty against defect or breakage. Flexicore patent Nos. 2,244,735 and 2,849,870
27" (68.5 cm) deep,
18-1/2" (47 cm) wide,
46" (117 cm) high; 26" (66 cm) with handle folded down.
Remove one bolt and slide drum off shaft.
Weight: 92 lbs. (42 kg) without cable
100 ft. x 9/16" (30m x 14.2)
75 ft. x 5/8" (22.5m x 15.8)
1/3 hp with capacitor, forward-off-reverse switch, 20 ft. power cord and ground fault circuit interrupter.
Pneumatic, with no electrical contact between pedal and motor.
Power Cable Feed:
Drives and retracts at variable speed of up to 20 ft. per minute.
10" Heavy-duty wheels with roller bearings.
Passive wheel brake system holds the machine in place on the job or in the truck.
Heavy-duty V-belts running on nylon rollers.
Truck Loading Wheel:
Enables one person to lift machine onto bed of truck.
Cutter Holder on frame keeps all of the cutters within easy reach.
With double-reinforced palm for hand protection when guiding cable.
Left-wound Flexicore® wire rope center. 3/4" for 4" to 10" lines and 3" lines without sharp bends;
5/8" diameter for 3" to 6" lines;
1/2" diameter for 2" to 3" lines.
Cable Guide Tube:
Adds safety when you can't get machine close to drain opening. 5 ft. extensions available.